How to use dsh-sdk-jsonrpc-server

This article is derived from the plugin's already-indexed fields (wiki / faq / compatibility_json / readme), not freshly generated by AI. Source field is noted at the end of each section.

Quick start

Stdio JSON-RPC server plugin for out-of-process DeepSeek Harness SDK clients

— source: plugins.ai_summary

Install & verify

dsh plugin --profile web add npm:@deepseek-ai/dsh-sdk-jsonrpc-server

Run the command above in your DSH Web Profile. Then enable the plugin in the plugin list.

— source: plugins.install

Key points

• The wire has no per-session close or prompt-cancel method — SDK-created agents remain live until process shutdown.
• There is no per-prompt result — MessageId identifies inbox admission only; clients that own an automation interval must define and observe that interval themselves.
• stdout purity is deployment-enforced — a surrounding config can still load a stdout logger and corrupt the JSON-RPC channel; this plugin does not inspect or veto sibling loggers.
• Automatic adapter mounting is DeepSeek-specific — initialize can reuse any pre-registered model adapter, but its only fallback mounts dsh-llm-deepseek.

— source: plugin_wiki.readme_en (fallback readme_raw)

Pitfalls

Review the upstream repo before installing. This guide is auto-derived from indexed fields and may lag the latest release. If anything contradicts the official docs, treat the upstream source as authoritative.

— source: general rule